| Usage:
To provide removable panel on duct or access openings for service
or inspection. Approved: In 1 hour steel or timber stud walls and all masonry walls. Design: SFPI-MOD is available in a concealed type steel frame or pressed Zincanneal steel frames of selected profile. Panels are 38mm or 48mm thick with optional facings of plywood, MDF, formica fire retardant grade, laminate, Zincanneal or Marviplate clad steel. Heat activated expanding seals for 'hot' smoke protection are available. |
|
| Usage:
Designed to protect duct or access openings from spread of smoke,
hot gases and fire, these panels provide ready access by simply removing
screw fixings. Approved: For use in 2 hour steel stud and fire rated masonry walls. Design: FP2-S11-MOD is available in pressed Zincanneal frame as shown, but may also be fitted in frame of steel for concealed flush mounting as shown in Fig. 1 above. Optional facings as for SFPI-MOD design are available. |
|
| Usage:
For fire protection in high fire-risk openings. Approved: For use in all fire rated masonry walls, aerated concrete or 'Lok-Blok' brand gypsum block walls. Design: SFP4 is presented in pressed Zincanneal steel frames to selected profile of single or double rebate. Facing is an acrylic/granular coating of proprietary brand, factory applied and providing good protection from weather. Panels are 60mm (nom) thickness and are screw fixed with 10g self-tapping plated steel screws at 450mm centres. |
|
| Usage:
Cavity shaft wall where temporary access may be required. Approved: For use in Australian Gypsum Ltd. 2 hour rated cavity shaft wall. Design: FFH4 with fire retardant treated plywood facings and available in pressed steel frame of profile as illustrated. Panels may be screw fixed or hinged and locked with steel 'Budget' locks. In addition, 'cold and hot smoke' seals are available where specified. Generally supplied as factory fitted assemblies to be screw fixed into pre-formed and measured openings. |
|
| Specifically
designed for lift motor room and plant room hatches. These units (which
incorporate a checker plate steel cover plate) are manufactured to
size including the special profile, four side pressed Zincanneal steel
frame suitable for casting into concrete floors. The fire resistant
panels are faced with non-combustible sheet material and have anodized
aluminium channel edges to provide a robust lightweight floor hatch. The fixing is optional as screws, masonry anchors or hinged, with recessed finger grips provided. Finger holes are provided in the checker plate steel cover for ease of removal. Pair hatches are also available with removable support pillion. |
|
These large screw fixed
panels are available to suit wall penetrations up to 2400mm x 1200mm
and have been tested with pipe penetrations and with facings of
plywood, galvanized steel and Marviplate. |
|
